![]() ![]() Most engineers try to remove as much low-end in their mix as possible for a cleaner mix. Layering your bass might seem like a counterintuitive technique. Tip #2: Layer Your Bass With Special Layers For Extra Power Place all your vocals in a group bus – the doubles should feel like a slight air that enhances the main vocal in the center.Īgain, you can apply this type of processing on a wide selection of tools – from multiband compressors to reverbs.You can also remove some of the top ends of these vocals with the mid setting on With the side setting on, remove some of the lower-mid frequencies of the doubles so that these vocals have less weight.Using your eight-band EQ, activate your Mid/Side option on the left side of the window.Record doubles of the same vocal line and place them left and right respectively.Record your primary vocal and place it at the center of your stereo image.I’ve laid out a handy mid/side technique for layering vocals below: You can apply separate processing to the center and side signals of a stereo track.Ī lot of stock audio effects and plugins come with either a Mid/Side or Left/Right extensions.Ībleton’s eight-band EQ is one of the simplest tools to use while learning this technique. The idea behind Mid/Side processing is quite simple. It’s especially useful when you want to clean up a stereo image without reducing all of the audio information on hand. Mid/Side processing is a very underutilized technique in mixing. Tip #10: Automating Filters On Effects Tip #1: Use Mid/Side Processing For Clean Stereo Image & Mono Compatibility.Tip #6: Sidechain Your Reverb/Delay Send.Tip #5: Make Sure To Leave Enough Headroom On Your Master Track.Tip #3: Mix in Mono For Incredible Mono Compatibility.Tip #2: Layer Your Bass With Special Layers For Extra Power.Tip #1: Use Mid/Side Processing For Clean Stereo Image & Mono Compatibility.
0 Comments
Leave a Reply. |